User manual

GMC-I Messtechnik GmbH 69
If no further matches are found, the message shown above is dis-
played.
16.4 Saving Data and Generating Reports
Preparing and Executing a Measurement
Measurements can be performed and stored to memory for each
structural element. Proceed as follows, adhering to the prescribed
sequence:
➭ Select the desired measurement with the rotary knob.
➭ Start the measurement by pressing the ON/START or IΔ
N
key.
Upon completion of measurement, the “→ Floppy Disk” softkey is
displayed.
➭ Briefly press the “Save Value” key.
The display is switched to the memory menu or the
structural view.
➭ Navigate to the desired memory location, i.e. to the desired
structural element / object, for which the measurement data
will be saved.
➭ If you would like to save a comment along with the
measurement, press the key shown at the right and
enter a designation via the “EDIT” menu as described in
section 16.3.1.
➭ Complete data storage by pressing the “STORE” key.
Storage of Error Messages (Pop-ups)
If a measurement is completed without a measured value being
produced on account of an error, this measurement can be saved
to memory along with the pop-up via the „Save Value“ key. In the
ETC the corresponding text is given out instead of the pop-up
smybol. This only applies to a limited selection of pop-ups, see
below. In the database of the test instrument, neither the symbol
nor the text can be retrieved.
Alternative Storage Procedure
➭ The measured value can be saved to the last se-
lected object in the structural diagram by pressing
and holding the “Save Value” key, without switching
the display to the memory menu.
Note
If you change the parameters in the measurement view,
they are not saved for the structural element. A measure-
ment with changed parameters can nevertheless be
saved to the structural element, and any changed param-
eters are documented in the report for each measure-
ment.
Retrieving Saved Measured Values
➭ Switch the display to the distributor structure by pressing the
MEM key and select the desired electrical circuit with the scroll
keys.
➭ Switch to page 2
by pressing the key shown here:
➭ Display the measurement data
by pressing the key shown here:
One measurement with date
and time, as well as any com-
ment you might have entered, is
displayed in each screen.
Example:
RCD Measurement
Note
A check mark in the header means that the respective
measurement has been passed.
An X means that the measurement has not been passed.
➭ Scrolling amongst measurements
is possible with the keys shown here:
➭ The measurement can be deleted with the key
shown here:
A prompt window asks you to confirm dele-
tion.
With the help of the key shown at the right (MW: mea-
sured value / PA: parameter), the setting parameters
can be displayed for this measurement.
➭ Scrolling amongst measurements
is possible with the keys shown here:
Search for ID number
Search for text
End search
Search for ID number or text