User manual

4 GMC-I Messtechnik GmbH
Table of Contents Page
1 Safety Precautions .....................................4
2 Applications ...............................................6
3 Initial Startup .............................................7
3.1 Mains Connection ........................................7
3.2 Testing the LEDs ..........................................7
3.3 Connecting the Mode 2/3 Charging Cable ......7
4 Measurement with Test Instruments .........8
4.1
Measuring Protective Conductor Resistance (Rlo) ........8
4.1.1 Mode 2 Charging Cable ........................................8
4.1.2 Mode 3 Charging Cable ........................................8
4.2 Measuring Insulation Resistance (RISO) ..........8
4.3 Tripping Test with Nominal Residual Current and
Measurement of Time to Trip at Mode 2
Charging Cable ............................................9
5 Measuring RC ............................................9
6 Protective Conductor Current Measurement
(I
PE
) at Mode 2 Charging Cable .................9
7 Fault Simulation .......................................10
7.1 Mode 2 Charging Cable
(single-phase) ...........................................10
7.1.1 Simulated Interruption ........................................10
7.1.2 Simulated Wire Reversal ....................................10
7.1.3 Simulation of PE to Phase – PE-U
EXT ...............10
7.2 Mode 2 Charging Cable
(single-phase) ...........................................11
7.2.1 Simulated Interruption ........................................11
7.2.2 Simulation of PE to phase ....................................12
8 Characteristic Values ...............................13
9 Maintenance ............................................14
9.1 Housing Maintenance .................................14
9.2 Technical Safety Inspections
Testing per DGUV Rule 3 ............................14
9.2.1 Testing Protective Conductor Resistance R
PE ...............14
9.2.2 Testing Insulation Resistance ...............................15
9.2.3 Touch Current Measurement ...............................15
9.3 Fuse Replacement ......................................16
9.4 Return and Environmentally Sound Disposal .16
10 Repair and Replacement Parts Service
Calibration Center and Rental Instrument
Service .....................................................16
11 Product Support .......................................16
1 Safety Precautions
The test adapter has been manufactured
and tested in accordance with the following
safety regulations:
IEC/EN 61010-1/VDE 0411-1,
IEC/EN 61577/VDE 0413-2,-4/
DIN EN 61557-16/VDE 0413-16
Safety of the operator, as well as that of the
test adapter and the charging cable, is only
assured when it’s used for its intended pur-
pose.
Read the operating instructions carefully and
completely before placing your test instrument
into service. Follow all instructions contained
therein. Make sure that the operating instructions
are available to all users of the instrument.
Read the operating instructions for the respective
test instrument as well, in particular the sections
concerning the R
PE
, R
ISO
and time-to-trip mea-
surements, as well as the tripping test.
Tests may only be performed by a qualified
electrician, or under the supervision and
direction of a qualified electrician. The user
must be instructed by a qualified electrician
concerning performance and evaluation of
the test (see also training seminars listed at
www.gossenmetrawatt.com).
PROFITEST⏐EMOBILITY Table of Contents – Safety Precautions