User manual

Edited in Germany • Subject to change without notice • PDF version available on the Internet
GMC-I Messtechnik GmbH
Südwestpark 15
90449 Nürnberg
• Germany
Phone: [phone]
Fax: [phone]
e-mail: [e-mail]
www.gossenmetrawatt.com
14 Maintenance
14.1 Battery Replacement
If the battery level indicator displays only minimal
remaining battery capacity (only one segment
appears, see figure at right), the batteries must be
replaced.
➭ Switch the instrument off and disconnect it from all measuring
circuits.
➭ Remove the battery compartment lid on the back of the in-
strument by loosening the two Phillips head screws.
➭ Remove the depleted batteries.
➭ Insert new batteries. Be sure to observe the polarity symbols
which are embossed into the floor of the battery compart-
ment.
➭ Replace the battery compartment lid and retighten the
screws.
After inserting new batteries, all four segments
should appear at the display.
14.2 Housing
No special maintenance is required for the housing. Keep outside
surfaces clean. Use a slightly dampened cloth for cleaning. Avoid
the use of cleansers, abrasives or solvents.
Return and Environmentally Sound Disposal
The instrument is a category 9 product (monitoring and control
instrument) in accordance with ElektroG (German electrical and
electronic device law). This device is subject to the RoHS direc-
tive. Furthermore, we make reference to the fact that the current
status in this regard can be accessed on the Internet at
www.gossenmetrawatt.com by entering the search term WEEE.
In accordance with WEEE 2012/19/EU and ElektroG, we
identify our electrical and electronic devices with the symbol
in accordance with DIN EN 50419 which is shown at the
right. Devices identified with this symbol may not be disposed of
with the trash. Please contact our service department regarding
the return of old devices (see address in section 15).
If the batteries used in your instrument are depleted, they must be
disposed of properly in accordance with valid national regulations.
Batteries may contain pollutants and heavy metals such as lead
(Pb), cadmium (Cd) and mercury (Hg).
The symbol at the right indicates that batteries must not
be disposed of with the trash, and must be brought to a
designated collection point.
15 Repair and Replacement Parts Service
Calibration Center* and Rental Instrument Service
If required please contact:
GMC-I Service GmbH
Service Center
Thomas-Mann-Strasse 16-20
90471 Nürnberg • Germany
Phone: [phone]
Fax: [phone]
e-mail [e-mail]
www.gmci-service.com
This address is only valid in Germany.
Please contact our representatives or subsidiaries for service in
other countries.
* DAkkS Calibration Laboratory for Electrical Quantities
D-K-15080-01-01 accredited per DIN EN ISO/IEC 17025:2005
Accredited measured quantities: direct voltage, direct current val-
ues, DC resistance, alternating voltage, alternating current values,
AC active power, AC apparent power, DC power, capacitance,
frequency and temperature
16 Product Support
If required please contact:
GMC-I Messtechnik GmbH
Product Support Hotline
Phone: [phone]
Fax: [phone]
e-mail: [e-mail]
Pb Cd Hg