User manual

64 GMC-I Messtechnik GmbH
Device and Measuring Parameters
6.2 List of all Parameters, Main Menus and Submenus
Menus
Parameters
Page: Header Menu / Submenu Function / Switch Position
0. disp 67: 0.diSP – Show/Hide Leading Zeros SEt/SYStEM All
Addr 78: Configuring Interface Parameters SEt/SYStEM Interface operation
APoFF 66: APoFF – Specified Time for Automatic Shutdown and Continuous On SEt/SYStEM All except PQ, W and Wh
bAtt 65: bAtt – Query Battery Voltage InFo Parameters query / all
bEEP 68: bEEP – Set Limit Value for Continuity Testing SEt
blight 67: bLiGht – Disable Deactivation of Background Illumination SEt/SYStEM All
Cap 68: CAP –
Scaling Factor for Cable Length Measurement (capacitive linear electric constant) SEt m
CLEAr 22: Measurement Data Recording – Memory Mode Operation, STORE Menu Function StorE Memory mode operation
CLAMP 68: CLiP – Set Transformation Ratio (current clamp factor) SEt A
dAtE 65: tiME /dAtE – Query Time/Date, 66: dAtE – Enter Date SEt/SYStEM All
dBrEF 68: dbrEF – Set Reference Value for Alternating Voltage Level Measurement SEt dB
demand time
70: dEMAnd tiME – Time Interval for Mean Value Generation (parameter for power measurement in memory mode) SEt/EnErGY W/VA/VAr
diplimit 71: SwELL and diP Limit – Trigger Thresholds for Brief Overvoltages and Undervoltages SEt/MAinS PQ
energy 70: EnErGY Submenu SEt/EnErGY W/VA/VAr
energy Store
70: EnErGY StorE – Scope of Stored Values for Power and Energy Measurements SEt/EnErGY W/VA/VAr
events
67: EVEntS – Event Counter Sampling Rate and Trigger Thresholds SEt/EVEntS V V
harm
73: HArM – Harmonic Analysis Parameter SEt/HArM A/~ (THD)
hivolt
71: LoVolt and HiVolt – Trigger Thresholds SEt/MAinS PQ
hyst 75: HYSt – Hysteresis (parameter for memory mode operation) StorE Memory mode operation
1nfo 65: Querying Parameters – InFo Menu (as moving letters) InFo Parameters query / all
irStb 78: Configuring Interface Parameters SEt/SYStEM Interface
lovolt 71: LoVolt and HiVolt – Trigger Thresholds SEt/MAinS PQ
mains
71: MAinS – Mains Disturbance Recording Parameter SEt/MAinS PQ
mains. f
71: MAinS.F – Select Line Frequency SEt/MAinS PQ
mains Range 71: MAinS rAnGE – Select a Measuring Range for Mains Disturbance Recording SEt/MAinS PQ
0CCvP 65: Querying Parameters – InFo Menu (as moving letters) InFo Memory occupancy / all
rAtE
74: rAtE – Transmission and Storage Rate SEt/EnErGY Memory mode operation
r_sl
68: r_SL – Set Limit Value for Low-Resistance Measurement SEt

SEnd 77: Activating the Continuous Transmission Mode SEnd Interface operation
SET 66: Entering Parameters – SETUP Menu SEt Parameters menu
StArt
22: Measurement Data Recording – Memory Mode Operation, STORE Menu Function
StorE
Memory mode operationStoP StorE
Store 74: StorE Submenu – Parameters for Memory Mode Operation StorE