User manual

52 GMC-I Messtechnik GmbH
Device and Measuring Parameters
Note
The auto power off function (APoFF parameter) is deactivated
when dangerous touch voltage is applied.
CLiP – Set Transformation Ratio (current clamp factor)
See section 5.7.3 ff.
bEEP – Set Limit Value for Continuity Testing
1nFo
 ...  SET t iME  ...  bEEP
bEEP SET: 1, 10, 20 ... 500  
(10  = default setting)
tEMP unit – Select a Unit of Measure for Temperature
1nFo
 ...  SET t iME  ...  temp unit °C
unit SET: °C / °F 
(°C = default setting)
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER