User manual

48 GMC-I Messtechnik GmbH
Device and Measuring Parameters
6 Device and Measuring Parameters
The instrument’s “SET” mode (menu mode) makes it possible to
set operating and measuring parameters, query information and
activate the interface.
➭ The menu mode is accessed by pressing the MEASURE | SETUP
key, assuming that the instrument is switched on and set to
“Measure” (measuring mode operation). “1nFo” appears at the
display.
➭ By repeatedly pressing the
  key (in any direction), ac-
cess is gained to the following main menus: “store”, “ send” and
“set”, and the display is finally returned to“1nFo”.
➭ After selecting the desired main menu, the respective sub-
menu is accessed by pressing the FUNC | ENTER key.
➭ The desired parameter is selected by repeatedly pressing the
 key.
➭ In order to check or change a parameter, acknowledge it with
the FUNC | ENTER key.
➭ The
  keys can be used to position the cursor at the entry
position. The desired value is selected with the help of the
 keys.
➭ Changes can only be applied with the FUNC | ENTER key.
➭ After pressing the ZERO | ESC key, the display is returned to the
submenu without making any changes, and by pressing the
ZERO | ESC key once again, to the main menu etc.
➭ You can switch to the measuring mode from any menu level by
pressing the MEASURE | SETUP key.
After repeatedly pressing the MEASURE | SETUP key (without first
turning the multimeter off), you can return to the last selected
menu or parameter from the measuring mode.
Example: Setting Time
1nFo  ...  set  ...  t iME ... set
10:24:48 (hh:mm:ss)
 
Setting hours and minutes:
  Advance to desired entry position.
 Change the setting, the entry position blinks.
Press and hold the key to change the setting rapidly.
The new time setting is activated after acknowledg-
ment.
MEASURE
SETUP
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER
FUNC
ENTER