User manual

GMC-I Gossen-Metrawatt GmbH 25
11 Accessories
USB X-TRA Bidirectional Interface Adapter
This adapter makes it possible to connect the calibrator to a USB
port at a PC. The adapter allows for data transmission between
the calibrator and the PC.
METRAwin90-2 Software (in preparation)
This software allows for paperless documentation and
management of calibration results, as well as remote control of
the calibrator.
METRAHIT CAL sequence controls can be implemented online, or
offline after downloading complete calibration sequences.
The following conditions must be fulfilled in order to allow for use
of METRAwin90-2 :
Hardware
:
– IBM compatible Windows PC, 200 MHz Pentium processor or faster and at
least 64 MB RAM
– SVGA monitor with at least 1024 x 768 pixels
– Hard disk with at least 40 MB available memory capacity
–CD ROM drive
– Microsoft compatible mouse
– Windows supported printer
– 1 USB port for the use of USB X-
TRA
Software requirements:
– MS Windows 95, 98, ME, NT 4.0, 2000 or XP