Datasheet
4 GMC-I Messtechnik GmbH
METRAHITWORLD
International TRMS Multimeter
Power Supply
Battery 2 x 1.5 V AA size batteries,
alkaline manganese per IEC LR6 or
equivalent rechargeable NiCd battery
Service life With alkaline manganese:
approx. 750 hours for V , A
approx. 200 hours for V , A
Battery test is displayed automatically if battery
voltage drops to below approximately 2.1 V.
Electrical Safety
Safety class II per IEC 61010-1:2010/EN 61010-
1:2010/VDE 0411-1:2011
Measuring category 1000 V CAT III, 600 V CATIV
Nominal voltage 1000 IV
Pollution degree 2
Test voltage 6.7 kV~ per IEC 61010-1/EN 61010-1
Fuses
Fuse links for all ranges
up to 600 mA FF 1.6 A/1000 V, 6.3 mm x 32 mm,
switching capacity: 10 kA at 1000 V~ with
ohmic load, protects all current measuring
ranges up to 600 mA in combination with
power diodes
Fuse links for all
ranges up to 10 A FF 10 A/1000 V, 10 mm x 38 mm,
switching capacity: 30 kA at 1000 V with
ohmic load, protects 6A and 10 A ranges
to 1000 V
Data Interface
Type Optical via infrared light through the
housing
Data transmission Serial, bidirectional (not IrDa compatible)
Protocol Device specific
Baud rate 9600 baud
The USB plug-in interface adapter (see accessories) is used for
adaptation to the PC’s USB port.
Ambient Conditions
Accuracy range 0 °C ... + 40 °C
Operating temp. –10 °C ... + 50 °C
Storage temperature –25 °C ... + 70 °C without batteries
Relative humidity 45 ... 75%, no condensation allowed
Elevation to 2000 m
Mechanical Design
Protection IP 40, IP 20 at the connector jacks
per DIN VDE 0470, part 1 / EN 60529
Dimensions 84 mm x 195 mm x 35 mm
Weight Approx. 350 gr. with battery
Applicable Regulations and Standards
Standard Equipment
1 TRMS-digital multimeter
1 protective rubber holster
2 2 x 1.5 V AA size batteries
1 set of measurement cables KS17-2
1 DAkkS calibration certificate
1 short-form operating instructions
Detailed operating instructions are available on our website
www.gossenmetrawatt.com.
IEC 61010-1/EN 61010-1/
VDE 0411-1
Safety requirements for electrical equipment for
measurement, control and laboratory use
EN 60529
VDE 0470, Part 1
Test instruments and test procedures
Protection provided by enclosures (IP code)
DIN EN 61326-2-1
VDE 0843-02-2-1
Electrical equipment for measurement, control and labo-
ratory use – EMC requirements –
Part 2-1: Particular requirements for sensitive test and
measurement equipment
DIN EN 60529
DIN VDE 0470 Part 1
Test Instruments and test procedures
– Degree of protection provided by enclosures (IP code)