User manual

8 GMC-I Messtechnik GmbH
1.6.3 Transient Operation Menu
Press key in desired mode to enable its transient operation, and press key to enter into transient setting menu, which is
shown as below:
Note
Transient operation may be used in CC, CV, and CR modes.
1.6.4 List Operation Menu
Press key and key to enter into the list operation menu, which is shown as below:
Press ▲ and ▼ keys in list operation menu to select Data: <New/Edit>, and select New or Edit with the knob or ◄ and ► keys.
Then press key to Enter into sequence data editing status, which is shown as below:
MODE : CPC
POWR : 0.000W
Constant power-current source mode
Immediate power level
Function Description Example
LevelL Transient low level 1.000 A
LevelH Transient high level 2.000 A
TimeL Time for transient low level 600.00 ms
TimeH Time for transient high level 600.00 ms
TimeR Time for transient rising edge 0.01 ms
TimeF Time for transient falling edge 0.01 ms
MODE Continuous (Cont) Pulse (Puls) Toggle (Togg) Cont
Function Description
No. Select sequence (list) number (0-6)
Memo Sequence memo (10 characters)
Data: <New/Edit> Create a new or edit an existing sequence
Count Cycle times (1-65535)
Chain: Off Sequence number to be chained with (0-6, off)
Function Description
01. 10000.00000s
CCH 5.000A
Sequence (list) number Time
Mode Setting value
Function / Parameter Description