User manual

46 GMC-I Messtechnik GmbH
4.13 Triggered Operation
When the triggering mode is EXTernal, the triggered operations are shown below:
1 Set pending trigger function (see section 2.8).
2 Press the key + key or trigger terminal (TRIG IN) to receive TTL falling edge, and a trigger occurs.
Example 1: Select “List” for the trigger function to trigger a sequence operation. The sequence is the one mentioned in Example 1 in
section 4.8.1.
The detailed operations are shown below:
For the above operating procedures, the corresponding SCPI commands should be:
TRIG:FUNC LIST Selects „LIST“ for trigger function
TRIG A trigger occurs
4.14 Main Menu
The operating procedures for the main menu are shown below:
1 Press the key to enter into the main menu.
2 Use ▲ and ▼ keys to select the menu item.
3 Use the knob or ◄ ► keys to select the parameter; or use Entry keys or the knob together with ◄ ► keys to input set value.
Press
key to exit the parameter modification or exit the main menu.
4 Press the Enter key to confirm.
5 Press the
key to exit the main menu.
4.14.1 Loading Default Values
Example: Load the default values.
The detailed operations are shown below:
Steps Description
Step 1 Select “List” in main menu for the trigger function (please see section 4.14.6 for detailed introduction).
Step 2
Press key + key or trigger terminal (TRIG IN) to receive TTL low level. The load‘s input will change accordingly when
the sequence parameters are changed. Pressing key + key has the same effect as pressing key + key
at this time.
Procedure Description Display
1 Press the key to enter into the main menu.
Load Default :
Yes *No
2 Use the knob or ◄ key to select the parameter “Yes”. Press the Enter key to confirm.
Load Default :
*Yes No
3
Press the key to exit the main menu.