User manual

GMC-I Messtechnik GmbH 43
4.8.3 Starting/Stopping the List
Example 1: Start the No.0 sequence, and stop the active sequence operation.
For the above steps, the corresponding SCPI commands should be:
LIST:RECALL 0 Recalls the number 0 sequence
LIST ON Starts sequence operation
LIST OFF Stops sequence operation
4.9 Battery Discharge Operation
Figure 1.1 Battery discharge operation diagram
The operating procedures for battery discharge operation are shown below:
1 Press the key to turn off the load, and connect the tested battery correctly.
2 Press the
key + key to enter into battery discharge operation screen.
3 Press the key to enter into battery discharge parameters edit screen. Use ▲ and ▼ keys to select the parameter. Use the
Entry keys or the knob together with ◄ ► keys to input termination voltage value and discharge current value. Press the Ente key
to confirm.
4 Press the
key to exit the battery discharge parameters edit screen.
5 Press the
key to turn on the load, and start battery discharge operation.
6 Press the key to turn off the load, and stop battery discharge operation.
7 Press the
key to clear the discharge time and discharge capacity of the battery.
8 Press the key + key to exit the battery discharge operation.
Steps Description Display
Step 1 Press and key to enter into sequence operation menu.
►No.: 1
Memo:
Step 2
Use Entry keys or knob to set the sequence number (No.) to 0, and press the Enter key to confirm (recall the sequence in EEPROM
assigned by the sequence number).
►No.: 0
Memo: Test Power
Step 3 Press the key to exit sequence operation menu.
0.000V 0.000A
0.000
A CCH OFF
Step 4 Press the key + key to activate sequence operation.
0.000V 0.0000A
1.0000A
LCCL ON
Step 5 Press the key + key to stop sequence operation.
0.000V 0.000A
0.000
A CCH OFF
E Load