User manual

ManualsBrandsGOSSEN METRAWATT ManualsLaboratory & Bench PSUsBench PSU (adjustable voltage) 0 - 52 Vdc 0 - 100

GMC-I Messtechnik GmbH 39

bAud – Setting Transmission Speed (RS 232C)

• Specifies transmission speed in bits per second.

• The baud rate is an operating parameter of the serial interface.

• A low baud rate should be used in the case of large distances

between communicating devices and in EMC-critical

environments.

• Settings at the SSP KONSTANTER and the controller must be

identical.

• The baud rate can be set to one of the following values:

50, 75, 150, 200, 300, 600, 1200, 1800, 2400, 3600, 4800,

7200, 9600 or 19,200 bits per second.

Settings

☞ Procedure for selecting bAUd, and setting the desired

transmission speed (see chapter 4.7).

! bAUd appears in the bUS display along with the related

parameter (transmission speed).

Figure 4.7.4 b Path to Selection of the bAUd Text Parameter

dbit – Selecting the Number of Data Bits (RS 232C)

• Either 7 or 8 data bits can be used.

• Settings at the SSP KONSTANTER and the controller must be

identical.

Settings

☞ Procedure for selecting dbit and the desired number of data

bits (see also chapter 4.7).

! dbit appears in the bUS display along with the related

parameter (number of data bits).

Figure 4.7.4 c Path to Selection of the dbit Text Parameter

Pbit – Setting the Parity Bit (RS 232C)

• Parity or check bits are used to detect transmission errors.

• They are added to the character string so that the sum of H or

L is even or odd as defined.

• The parity bit can be set to one of the following values:

none no parity bit

ZEro always 0

EVEn even numbered

odd odd numbered

nonE always 1

! A parity bit should always be used in EMC-critical

environments.

! Settings at the SSP KONSTANTER and the controller must be

identical.

Settings

☞ Procedure for selecting Pbit and setting the parameter (see also

chapter 4.7).

! Pbit appears in the bUS display along with the related

parameter (parity bit).

Figure 4.7.4 d Path to Selection of the Pbit Text Parameter

Select the text parameter

from an options loop

From the bUS function group

ENTER

CE/LOCAL

FUNCTION SAVE

RCL

FUNCTION

SAVE

RCL

FUNCTION

Activate

the setting

Abort

without change

From the bUS function group

ENTER

CE/LOCAL

FUNCTION SAVE

RCL

FUNCTION

SAVE

RCL

FUNCTION

Activate

the setting

Abort

without change

Select the text parameter

from an options loop

From the bUS function group

ENTER

CE/LOCAL

FUNCTION SAVE

FUNCTION

SAVE

RCL

FUNCTION

Activate

the setting

Abort

without change