User manual

8 GOSSEN-METRAWATT
3 Getting started
3.1 Installing ribbon and batteries
Before getting started insert the ribbon (see section 13.4, page 40).
To store the data in the PSI module and to transmit the data to the PC, four commercially available
1.5 V Mignon cells according to IEC LR 6 are required when the PSI module is not powered from the
appliance tester.
Note
Only alkaline-manganese cells that comply with the IEC LR 6 standard are to be used.
The use of manganese-dioxide cells is not recommended as their lifespan is too short.
Always replace the complete battery set. Dispose of the batteries in a way that protects the environ-
ment.
The battery compartment (10) is located at the rear of the printer.
Free the catch by exerting lateral pressure on the clamping bow of the cover of the battery com-
partment and remove the cover. The battery holder falls out of the battery compartment when you
tilt the module.
Insert four 1.5 V Mignon cells into the battery holder with correct polarity according to the given
symbols.
Insert the equipped battery holder into the battery compartment.
Attach the cover of the battery compartment to the battery compartment and engage it by exert-
ing a slight pressure.
Note
When replacing the batteries, stored data is saved in the memory even if no voltage is
applied for about 5 minutes.
If no batteries were inserted for a longer period of time, e.g. after delivery from the fac-
tory, a reset should be performed. This makes for a defined condition to the established.
See combined keyboard instructions on page 3 for making a reset.
3.2 Installing the PSI module
From the lid of the SECUTEST 0701S, remove the cover on which the symbols are printed. For
this purpose, press the cover to the side.
Insert the PSI module into the lid and fasten it with the two knurled retaining screws (5).
Connect the module to the connection socket of the RS-232 interface of the appliance tester via
the ribbon cable (8).
Below the PSI module there is a compartment provided for the storage of the probe lead. Lock the
flap (18) inserted in the module on the hinge of the lid so that the probe lead will not fall out when
the lid is closed.