User manual

GOSSEN-METRAWATT 39

Take care that the print mechanism can be switched on when the key (12) is pressed.

For this purpose, sufficiently charged batteries must be installed. If the batteries are not to be

used, connect the PSI module to the SECUTEST 0701S – e.g. via an interface cable as extension

cable.

Slide the front end of the paper strip into the guide slot of the print mechanism and simultane-

ously press the key (12), keep the key pressed until the front end of the paper appears at the

paper outlet.

Prior switch-on of the PSI module is required for battery mode (see section 8, page 22).

First insert the metal axle for paper advance (2) into the paper roll (3), then, together with the pa-

per roll into the two holders at the sides of the paper compartment.

Fold the paper tear-off edge (7) back and close the cover of the paper compartment (1) so that

the catch engages audibly.

13.4 Maintenance case

Special maintenance of the case is not required. Ensure a clean surface. Use a slightly moist cloth for

cleaning. Do not use detergents and scouring agents.

Guide slot

Paper compartment

Paper roll

Metal axle for

paper advance