User manual

22 GOSSEN-METRAWATT

8 Battery mode

If the PSI module is not connected to the SECUTEST 0701S, only battery mode with the following

functions is possible:

– Paper speed

– Data exchange with a PC

Note

Even with the PSI module connected, batteries must be inserted so that the data can be

saved. Power for all other functions is then supplied by the tester.

Switching the PSI module on

Press the key (17) until the signal lamp (9) lights.

Switching the paper speed on

Press the key (12). The paper speed is switched on as long as you keep the key pressed.

Data exchange with a PC

Connect the PC to the RS-232 connection socket (4) of the PSI module via an interface cable

(see section 9, page 24).

Automatic switch-off

The battery is automatically switched off

– If the key for the paper speed is not pressed within 10 seconds after switch-on

– If there is a pause of more than 10 seconds in the data transfer with the PC.