User manual

GOSSEN-METRAWATT 21
7.3 Reading bar codes
Point the reader to the bar code to be acquired (max. distance 1 cm) and press the button on the
reader.
A correct reading is confirmed by a sound signal.
Setting
Code (instruction)
from operating instructions
Sound
signal
Remarks
Start configuration Enter configuration mode 4 x
Set protocol for
RS-232 interface
to XON/XOFF
C1 x
Setting is always
required for operation
with PSI module!
E1 x
11 x
Each bar code
should be read once
B1 x
RecommendedC1 x
01 x
Save and end
configuration
Esc and save
1 x
+ 4 x
In the case of reading errors 3 x