User manual

14 GOSSEN-METRAWATT
5.2 Automatic protocol storage
All test results are automatically given a successive ident number* provided the Autostore function is
active. After the safety test as well as after the function test, a note is displayed at a time to show that
the test data is stored.
Open the Setup menu in the SECUTEST 0701S with the PSI module deactivated (switch position
MENU), and there select the Configure menu.
Move the cursor to Autostore: Press , this switches the function on or off.
* It consists of a max. of 24 numerals. Only the first four numrals are used;
counting begins with 0001.
5.3 Quick protocol storage
If many measurements are to be made successively and the results are to be evaluated later, the
function "Quick protocol storage" is offered. This function can only be used after a test (safety test
and/or function test).
Activate the PSI module with .
This brings you directly to the enter field for
the ident number. Here, you can enter
a max. of 24 digits and confirm with .
To store, press the key once more.
The protocol is stored in thedatabase of the PSI module
together with all available data. Empty data fields are
ignored. At the same time you return to measuring mode to
immediately start the next measurement.
Note
If a Reset has been made accidentally after the test, e.g. by changing the position of the
function switch or pulling the interface cable off, the ident number must again be
entered in the protocol. The data is saved.
STORE
ENTER
STORE