Manualshelf

Instructions

ManualsBrandsGossen Metrawatt Manuals(Rechargeable) Battery AccessoriesGossen Metrawatt Battery tester B100B Reading range (battery testers) < 600 V Rechargeable, Battery B100B
11121314151617181920
10
GMC-I Messtechnik GmbH METRACELL BT PRO
4 Initial Startup
These condensed operating instructions only explain initial startup of the instrument and
basic operating procedures. Please refer to the full operating instructions for a complete
description of all functions and settings (available at http://www.gossenmetrawatt.com).
1. Electrical Power Supply 10
2. Attach the Carrying Strap (optional)
11
3. Switching the Instrument On
11
4. Getting Started 12
4.1 Electrical Power Supply
The battery tester is operated with rechargeable NiMH batteries. Pre-charged batteries are
shipped loose. These must be inserted before initial use.
Attention!
!
Risk of injury due to contact with dangerous voltages.
Only use the instrument when the battery compartment cover is inserted and firmly
screwed into place.
Required tools: Philips screwdriver
The battery tester must be switched off.
All measurement cables and accessories must be removed from the instrument.
1. Remove the holster from the instrument: Press against the bottom of the holster at the
front and push it back and off of the instrument. As soon as the lower part of the instru-
ment is exposed, pull the instrument completely out of the holster.
2. Place the instrument face down on a stable surface.
3. Loosen and remove the screw from the battery compartment cover.
4. Unlock and remove the battery compartment cover.
5. Insert the 4 included rechargeable batteries into the battery compartment, making sure
that the plus and minus poles match up with the provided polarity symbols.
Attention!
!
Only the included batteries or those specified in the technical data (8) may be
inserted and used.
6. Place the battery compartment cover onto the battery compartment and press it until it
audibly clicks into place.
7. Secure the battery compartment cover with the screw.
8. Pull the holster back over the instrument: Observe the cut-outs in the holster for the front
panel and the connections. Push the instrument into the holster at the top first as far as it
will go. Then press on the front at the bottom until the instrument is fully reinserted into
the holster.
The batteries have now been inserted. The instrument can be used.