Owners manual

Step 3
Attach the connection bar onto the front axle sub-assembly using M6x17 shoulder
bolts (2), M6 washers (2), M6 lock nuts (2) M10 washer (1) and cotter pin (1).
Step 2
Attach the front strut and yoke to the front axle sub-assembly using M8x170 carriage
bolt (1), M8 washer (1) and M8 lock nut (1). Tighten securely.
Paso 3
Fija la barra de conexión al subensamblaje del eje delantero con (2) pernos de hombro
M6x17, (2) arandelas M6, (2) contratuercas M6, (1) arandela M10 y (1) pasador de
chaveta.
Step 4
Attach the front axle assembly and front strut to the bed using M8x20 carriage bolts
(2), M8 washers (2) and M8 lock nuts (2).
NNOOTTEE:: tthhee hhaarrddwwaarree ttoo aattttaacchh tthhee ffrroonntt
ssttrruutt ttoo tthhee bbeedd iiss pprree--aasssseemmbblleedd ttoo tthhee ssttrruutt..
AA..
Place the front axle assembly and front strut onto
the bed. Attach the front strut to the bed first. Place
the M8x25 carriage bolt (pre-assembled to the strut)
into the pre-punched hole on the bed and slide it into
place. Lift up slightly on the strut and tighten bolt
securely.
BB..
Next secure the
front axle assembly to
the bed using M8x20
carriage bolts (2), M8
washers (2) and M8
lock nuts (2). Tighten
bolts securely.
Paso 4
Fija el ensamblaje del eje delantero y el amortiguador delantero a la cama con (2)
pernos de carro M8x20, (2) arandelas M8 y (2) contratuercas M8.
NNOOTTAA:: eell hheerrrraajjee
ppaarraa ssuujjeettaarr eell aammoorrttiigguuaaddoorr ddeellaanntteerroo aa llaa ccaammaa eessttáá pprreeeennssaammbbllaaddoo ccoonn
eell aammoorrttiigguuaaddoorr..
AA..
Coloca en la cama el ensamblaje del eje
delantero y el amortiguador delantero. Primero fija el
amortiguador delantero a la cama. Coloca el perno
de carro M8x25 (preensamblado con el
amortiguador) en el orificio preperforado en la cama
y deslízalo en su lugar. Levanta ligeramente el
amortiguador y aprieta el perno firmemente.
BB..
Luego, asegura el
ensamblaje del eje
delantero a la cama
con (2) pernos de
carro M8x20, (2)
arandelas M8 y (2)
contratuercas M8.
Aprieta todos los
pernos firmemente.
4A
4B
4A
4B
Paso 2
Fija el amortiguador delantero y la horquilla en el subensamblaje del eje delantero
con un (1) perno de carro M8x170, una (1) arandela M8 y una (1) contratuerca M8.
Ajústalos firmemente.
M10 washer
Arandela M10