SDS
Table Of Contents
- Intended Use of the Product Adhesive.
- Emergency Telephone Number
- Classification of the Substance or Mixture
- GHS-US Classification
- Label Elements
- GHS-US Labeling
- Other Hazards
- Unknown Acute Toxicity (GHS-US)
- Substance
- Mixture
- Description of First-aid Measures
- Most Important Symptoms and Effects Both Acute and Delayed
- Indication of Any Immediate Medical Attention and Special Treatment Needed
- Extinguishing Media
- Special Hazards Arising From the Substance or Mixture
- Advice for Firefighters
- Personal Precautions, Protective Equipment and Emergency Procedures
- For Non-Emergency Personnel
- Environmental Precautions
- Methods and Materials for Containment and Cleaning Up
- Reference to Other Sections
- Precautions for Safe Handling
- Specific End Use(s) No use is specified.
- Control Parameters
- Information on Basic Physical and Chemical Properties
- Information on Toxicological Effects
- Toxicity
- Persistence and Degradability
- Bioaccumulative Potential
- Mobility in Soil1T No additional information available
- 13.1. Waste Treatment Methods
- US Federal Regulations
- US State Regulations
Gorilla Spray Adhesive SDS Page 8 of 18
Safety Data Sheet – Gorilla Spray Adhesive
Date Revised: 02/28/2017
Date Issued: 02/28/2017
Version 1.0
FOR CHEMICAL EMERGENCY
DURING BUSINESS HOURS: (800) 966-3458 | OUTSIDE BUSINESS HOURS: (800) 420-7186
According to Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules and Regulations.
USA NIOSH
NIOSH REL (STEL) (ppm)
15 ppm
USA IDLH
US IDLH (ppm)
250 ppm
USA OSHA
OSHA PEL (TWA) (mg/m³)
50 mg/m³
USA OSHA
OSHA PEL (TWA) (ppm)
10 ppm
Particulates not otherwise classified (PNOC) (Not applicable)
USA ACGIH
ACGIH TWA (mg/m³)
3 mg/m
3
Respirable fraction
10 mg/m
3
Total Dust
USA OSHA
OSHA PEL (TWA) (mg/m³)
5 mg/m
3
Respirable fraction
15 mg/m
3
Total Dust
Exposure Controls
Appropriate Engineering Controls
:
Emergency eye wash fountains and safety showers should be available in the
immediate vicinity of any potential ex
posure. Ensure adequate ventilation,
especially in confined areas. Gas detectors should be used when flammable gases
or vapors may be released. Oxygen detectors should be used when asphyxiating
gases may be released. Proper grounding procedures to avoid st
atic electricity
should be followed. Use explosion
-proof equipment. Ensure all national/local
regulations are observed.
Personal Protective Equipment
:
Gloves. Protective clothing. Protective goggles. Insufficient ventilation: wear
respiratory protection.
Respiratory protection of the dependent type.
Materials for Protective Clothing
:
Chemically resistant materials and fabrics. Wear fire/flame resistant/retardant
clothing.
Hand Protection
:
Wear protective gloves. If material is cold, wear thermally resistant protective
gloves.
Eye Protection
:
Chemical safety goggles.
Skin and Body Protection
:
Wear suitable protective clothing.
Respiratory Protection
:
Use a NIOSH-approved self-contained breathing apparatus whenever exposure may
exceed established Occupational Exposure Limits.
Thermal Hazard Protection
:
Wear thermally resistant protective clothing.
Environmental Exposure Controls
:
Avoid release to the environment.
Other Information
:
When using, do not eat, drink or smoke.
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Information on Basic Physical and Chemical Properties
Physical State
:
Gas
Appearance
:
No data available
Odor
:
No data available
Odor Threshold
:
No data available
pH
:
No data available
Evaporation Rate
:
No data available
Melting Point
:
No data available
Freezing Point
:
No data available
Boiling Point
:
57.6 °C (135.68 °F) estimated
Flash Point
:
-104.4 °C (-155.92 °F) Propellant - estimated