SDS

Gorilla Packaging Tape SDS 05/21/2015 Page 3 of 5
Safety Data Sheet
-
Gorilla
Packaging
Tape
Date Revised: 05/21/2015
Date Issued: 05/21/2015
FOR CHEMICAL EMERGENCY:
During Business Hours: [phone] | Outside Business Hours: [phone]
Version
:
1.0
According to Federal Register /
Vol. 77, No. 58 / Monday, March 26, 2012 / Rules and Re
gulations
Exposure Controls
Appropriate Engineering Controls: Emergency eye wash fountains and safety showers should be available in the immediate vicinity
of any potential exposure. Provide sufficient ventilation to keep vapors below permissible exposure limit. Ensure all national/local
regulations are observed.
Personal Protective Equipment: Gloves. Safety glasses.
Materials for Protective Clothing: Not available
Hand Protection: Chemically resistant gloves are recommended, but not required.
Eye Protection: Chemical goggles or safety glasses.
Skin and Body Protection: Wear suitable working clothes.
Respiratory Protection: Not required for normal conditions of use. Use a NIOSH-approved respirator or self-contained breathing
apparatus whenever exposure may exceed established Occupational Exposure Limits.
Other Information: When using, do not eat, drink or smoke.
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Information on Basic Physical and Chemical Properties
Physical State : Solid
Appearance : Clear
Odor : Slight, Sour
Odor Threshold : Not available
pH : Not applicable
Evaporation Rate : Not available
Melting Point : Not available
Freezing Point : Not available
Boiling Point : Not available
Flash Point : Not available
Auto-ignition Temperature : Not available
Decomposition Temperature : Not available
Flammability (solid, gas) : Not available
Lower Flammable Limit : Not available
Upper Flammable Limit : Not available
Vapor Pressure : Not available
Relative Vapor Density at 20 °C : Not available
Relative Density : Not available
Specific Gravity : Not available
Solubility : Non-soluble
Partition Coefficient: N-Octanol/Water : Not available
Viscosity : Not available
Explosion Data – Sensitivity to Mechanical Impact : Not expected to present an explosion hazard due to mechanical impact.
Explosion Data – Sensitivity to Static Discharge : Not expected to present an explosion hazard due to static discharge.