Owner Manual
Table Of Contents
- 2600 Interlocking Sandbox - Opening Pages
- 2600 Hardware
- 2600 Wood List and Accessories
- 2600 - Steps
- 2600 - Step 01
- 2600 - Step 02
- 2600 - Step 03
- 2600 - Step 04
- 2600 - Step 05
- 2600 - Step 06
- 2600 - Step 07
- 2600 - Step 08
- 2600 - Step 09
- 2600 - Step 10
- 2600 - Step 11 Option 1 Umbrella Bracket
- 2600 - Step 12 Option 1 Umbrella Mast Installation
- 2600 - Step 13 Option 1 Umbrella Completion
- 2600 - Step 14 Option 2 Sandbox Cover
OPTION 1: UMBRELLA BRACKET
IF YOU PURCHASED THE OPTIONAL UMBRELLA WITH YOUR SANDBOX THEN YOU WILL INSTALL
THE UMBRELLA BRACKET.
1: PLACE THE UMBRELLA BRACKET IN THE CORNER AS SHOWN. KEEP IN MIND THAT YOU WANT
TO KEEP THE HOLES IN THE BRACKET AWAY AS FAR AS YOU CAN FROM THE JOINS WHERE THE
BOARDS TOUCH.
2: THERE SHOULD BE ONE LEFTOVER #6 X 3/4" FLAT HEAD SCREW. IF YOU DO NOT HAVE A
1/16" DRILL BIT THEN YOU MAY USE THIS SCREW TO MAKE "PILOT" HOLES FOR THE PAN HEAD
SCREWS. RUN THE FLAT HEAD SCREW INTO EACH HOLE AND BACK IT BACK OUT. IF YOU DO
HAVE A 1/16" DRILL BIT THEN USE IT TO DRILL TO A DEPTH OF 1/2" AT EACH HOLE.
3: NOW INSTALL THE #12 X 3/4" PHILLIPS PAN HEAD SCREWS IN THE PREDRILLED HOLES. THE
UMBRELLA BRACKET SHOULD NOW BE SECURED IN THE CORNER OF THE SANDBOX.
A
SCALE 1 : 4
DETAIL A
#12 X 3/4"
KEEP THE HOLES AWAY FROM
THE JOINS WHERE THE BOARDS
MEET
UMBRELLA BRACKET
PHILLIPS PAN HEAD SCREW
USE THE LEFTOVER #6 X 3/4"
FLAT HEAD SCREW TO
MAKE PREDRILLED HOLES IN
THE SANDBOX BOARDS. IF
YOU HAVE A 1/16" DRILL BIT
YOU MAY DRILL 1/2" DEEP
HOLES TO DO THE SAME
THING.
21