Owner Manual
Table Of Contents
- 2600 Interlocking Sandbox - Opening Pages
- 2600 Hardware
- 2600 Wood List and Accessories
- 2600 - Steps
- 2600 - Step 01
- 2600 - Step 02
- 2600 - Step 03
- 2600 - Step 04
- 2600 - Step 05
- 2600 - Step 06
- 2600 - Step 07
- 2600 - Step 08
- 2600 - Step 09
- 2600 - Step 10
- 2600 - Step 11 Option 1 Umbrella Bracket
- 2600 - Step 12 Option 1 Umbrella Mast Installation
- 2600 - Step 13 Option 1 Umbrella Completion
- 2600 - Step 14 Option 2 Sandbox Cover
MITER JOINT
FLUSH TO THE VERTICAL INSIDE SURFACE OF THE SANDBOX.
TRY TO KEEP THE INNER EDGE OF SANDBOX BOARD 4
UP HERE.
SANDBOX BOARD 4
TRY TO KEEP THE MITER JOINT AND
THE OVERLAPPING JOINTS LINED
#6 X 1-1/2"
WOOD SCREW
(5 PER BOARD)
STEP 9: SANDBOX BOARD 4
1: PLACE THE SANDBOX BOARD 4 BOARDS AS SHOWN ON TOP OF THE SANDBOX. ALIGN THE
MITERED ENDS WITH EACH OTHER IN THE CORNERS. TRY TO KEEP THE INSIDE EDGE OF
SANDBOX BOARD 4 FLUSH TO THE VERTICAL INSIDE SURFACE OF THE SANDBOX BOARD. IF
THERE ARE SLIGHT GAPS AT THE MITER JOINTS THEN THOSE WILL BE COVERED UP IN THE NEXT
STEP.
2: FASTEN THE SANDBOX BOARD 4 TO THE BOARDS BENEATH IT WITH #6 X 1-1/2" WOOD
SCREWS. THERE WILL BE FIVE SCREWS USED PER BOARD.
3: GO AROUND THE SANDBOX FASTENING THE REMAINING SANDBOX BOARD 4 PARTS.
19