Owner Manual
Table Of Contents
- 2600 Interlocking Sandbox - Opening Pages
- 2600 Hardware
- 2600 Wood List and Accessories
- 2600 - Steps
- 2600 - Step 01
- 2600 - Step 02
- 2600 - Step 03
- 2600 - Step 04
- 2600 - Step 05
- 2600 - Step 06
- 2600 - Step 07
- 2600 - Step 08
- 2600 - Step 09
- 2600 - Step 10
- 2600 - Step 11 Option 1 Umbrella Bracket
- 2600 - Step 12 Option 1 Umbrella Mast Installation
- 2600 - Step 13 Option 1 Umbrella Completion
- 2600 - Step 14 Option 2 Sandbox Cover
THIS IS WHERE THE BOARD IS LOCATED IN THE
FINAL POSITION IN THE NEXT STEP.
THIS SANDBOX BOARD 3 IS BEING
USED AS A TEMPLATE TO MAKE
HOLES IN THE SANDBOX
BOARDS.
" 16
5
8
17
1
8
"
STEP 6: SANDBOX BOARD 3 HOLES
1: IN THIS STEP YOU WILL BE MAKING HOLES FOR THE SANDBOX BOARD 3 BOARDS.
2: THE SANDBOX BOARD 3 HOLES WILL BE USED AS A TEMPLATE TO MAKE HOLES IN THE
SANDBOX BOARD 1 AND 2 BOARDS.
3: PLACE A SANDBOX BOARD 3 BOARD INSIDE THE SANDBOX. THIS ONE WILL BE THE
TEMPLATE TO MAKE THE HOLES. THE OTHER SANDBOX BOARD 3 ON THE OUTSIDE WILL BE
THE FINAL POSITION OF THE BOARD AFTER IT IS ATTACHED IN THE NEXT STEP.
4: USE A SCREW TO MARK THROUGH THE HOLES IN THE TEMPLATE BOARD ONTO THE
SANDBOX BOARDS. THEN REMOVE THE TEMPLATE BOARD.
5: REPEAT THIS PROCESS FOR THE OTHER THREE SIDES.
16