Installation & Assembly

ManualsBrandsGorilla Playsets ManualsBackyard PlayPlastic Bucket Swing with Chains and Hooks

Table Of Contents

1. Insert the yellow T-bar into the hole at the front of the swing. If you need to

the child is placed into the seat.

Insert T-bar into hole at front of the seat.

T-Bar

the T-bar up. Under normal conditions the T-bar is always snapped into the seat before

disengage the T-bar you can squeeze the 2 tabs together under the seat while pulling

T-bar release tabs.

Infant Swing (04-0032)

Summary of content (7 pages)

PAGE 1
Infant Swing (04-0032) 1. Insert the yellow T-bar into the hole at the front of the swing. If you need to disengage the T-bar you can squeeze the 2 tabs together under the seat while pulling the T-bar up. Under normal conditions the T-bar is always snapped into the seat before the child is placed into the seat. T-Bar Insert T-bar into hole at front of the seat. T-bar release tabs.
PAGE 2
Infant Swing (04-0032) 2. Verify that the Seat Belt is oriented properly. The belt Buckle and the belt End Holder have teeth on them. The "teeth" should point towards the back of the swing. If the teeth do not face this direction, pull the belt out of the swing and flip it over before reinserting it. 3. On pages 4 and 5 there are pictures demonstrating the proper method to attach the rope buckle to the rope. Once the rope buckle is attached to the rope, pull the rope through to "level" the seat.
PAGE 3
Infant Swing (04-0032) 4. There are many different ways to connect the "rings" on the end of the ropes to swing hangers that exist on your swing set or custom swing. Always follow the manufacturer's directions on how to attach the swing to the swing hangers. 5. Safety comes first when swinging. Always obey the safety rules when swinging and when walking around a swing set. We have included a Safety Tips guide on page 6.
PAGE 4
Infant Swing Adjustment Step 1 Locate both ends of rope. 1 end with a round ring 1 end with buckle Step 2 Take end with ring and flatten, then fold in half and insert the looped rope through rear of buckle.
PAGE 5
Step 3 Fold buckle tab between 2 ropes. Then pull loop towards buckle to tighten.
PAGE 6
SAFETY TIPS FOR SWINGS  On-site adult supervision is required.  Teach children not to walk close to, in front of, behind, or between moving swings or other moving playground equipment.  Teach children to sit in and never stand on swings. (Exception to this rule is a product called "Stand -N- Swing")  Teach children not to twist the chains and ropes and not to loop them over the swing beam, since this may reduce the strength of the chain or rope.
PAGE 7
INFANT SWING HEIGHT ADJUSTMENT 04-0032 Green/Blue/Pink with yellow ropes If your infant swing is too close to the ground after adjusting the buckle all the way to the top then tie a knot in the each rope below the molded plastic rope cover located below the buckle. This should raise the infant swing up to an acceptable swinging level. Buckle at highest point Buckle Molded plastic rope cover Knot Molded plastic rope cover Tie a knot below the buckle and molded plastic cover.