Instructions / Assembly

A
1-1/2" WOOD SCREW
5/4 X 2 X 23"
LARGE RAY
5/4 X 2 X 16"
SMALL RAY
5/4 X 2 X 18"
SMALL RAY
ROOF SUPPORTS
SUN
DRILL HOLE 1/2"
FROM SIDE.
3/4"
DETAIL A
SCALE 1 : 6
1: LOCATE TWO 5/4 X 2 X 23" LARGE RAYS, TWO 5/4 X 2 X 16" SMALL RAYS AND TWO 5/4 X 2 X 18" SMALL RAYS.
2: PRE-DRILL ALL SMALL RAYS AT 3/4" ON CENTER FROM EACH END WITH A 1/8" DRILL BIT.
PRE-DRILL ALL LARGE RAYS 3/4" ON CENTER FROM THE BOTTOM END WITH A 1/8" DRILL BIT. PRE-DRILL THE TOP
END 3/4" FROM THE TOP END AND 1/2" FROM THE SIDE WITH A 1/8" DRILL BIT. (SEE DETAIL A) THIS IS NECESSARY
TO AVOID HITTING THE JOINT WHERE THE ROOF SUPPORTS MEET.
3: CENTER THE 5/4 X 2 X 23" LARGE SUNRAY ONTO THE SUN AND THE ROOF SUPPORT BOARDS AND FASTEN
WITH TWO 1-1/2" SCREWS.
4: EQUALLY SPACE THE SMALL RAYS ABOUT THE SUN ( THREE ON EACH SIDE OF LARGE RAY) AND MARK THE
POSITION OF THE SMALL RAYS WITH A PENCIL.
5: SECURE THE SMALL RAYS ONE AT A TIME TO THE SUN AND THE ROOF SUPPORTS AND LINE THEM UP WITH THE
MARK DRAWN. FASTEN THE SMALL RAYS WITH TWO 1-1/2" WOOD SCREWS EACH. REPEAT ON OTHER SIDE OF
FORT.
STEP 44: SUNBURST
77