Instructions / Assembly

A
LADDER
BOTTOM
PANEL
BOARD
3/4"
5/16" X 1-1/2" BOLT
5/16" WASHER
NOTE: T-NUT GOES IN BACK SIDE OF HOLE DRILLED
ON EACH SIDE.
BOTTOM
PANEL
BOARD
STEP 18: LADDER TO PLAY SET
1: THE LADDER WILL ATTACH TO THE REAR OF THE PLAY SET. PLACE THE LADDER AGAINST THE BOTTOM PANEL
BOARD CENTERED IN THE NOTCHED OUT AREA.
2: THE BOTTOM OF THE 90 BRACKETS SHOULD BE APPROXIMATELY 3/4" FROM THE BOTTOM OF THE BOTTOM PANEL
BOARD. USING THE 90 BRACKETS AS A TEMPLATE DRILL A 3/8" HOLE THROUGH THE BOTTOM PANEL BOARD.
3: FROM THE UNDERSIDE OF THE DECK INSERT A T-NUT INTO THE BACKSIDE OF THE 3/8" HOLES ON THE BOTTOM
PANEL BOARD.
4: ATTACH THE LADDER WITH 5/16" X 1-1/2" BOLTS AND 5/16" WASHERS.
5: WHEN THE 90 BRACKETS ARE SECURE, AND THE LADDER IS IN ITS FINAL POSITION TIGHTEN THE 5/16" X 1-1/2"
BOLTS ON THE INSIDE OF THE LADDER SIDES.
51