Instructions / Assembly

ROCK WALL

3/4"

5/16" X 1-1/2" BOLT

5/16" WASHER

NOTE: T-NUT GOES

IN BACK SIDE OF HOLE

DRILLED ON EACH SIDE.

FRONT FACE BOARD

STEP 16: ATTACHING THE ROCK WALL

1: PLACE THE ROCK WALL INTO POSITION ON THE FRONT SIDE - RIGHT OF THE PLAY SET AS SHOWN BELOW. THE

BOTTOM OF THE 90

BRACKETS SHOULD BE APPROXIMATELY 3/4" FROM THE BOTTOM OF THE FRONT FACE BOARD.

USING THE 90

BRACKETS AS A TEMPLATE; DRILL A 3/8” HOLE THROUGH THE FRONT FACE BOARD.

2: FROM THE UNDERSIDE OF THE DECK INSERT A T-NUT INTO THE BACKSIDE OF THE 3/8” HOLES ON THE FRONT FACE

BOARD.

3: ATTACH THE ROCK WALL WITH 5/16 X 1-1/2” BOLTS AND 5/16” WASHERS.

4: WHEN THE 90

BRACKETS ARE SECURE, AND THE ROCK WALL IS IN ITS FINAL POSITION; TIGHTEN THE 5/16 X 1-1/2”

BOLTS ON THE ROCK WALL SIDES.