Instructions / Assembly

5/16 X 4-1/2"
HEX BOLT
5/16" WASHER
2 X 6 X 70"
TOP PANEL BOARD
OFFSET HOLES UP
2 X 6 X 70"
FRONT FACE BOARD
OFFSET HOLES UP
2 X 6 X 70"
SANDBOX BOARD
OFFSET HOLES UP
FRONT OF PLAY SET
LEFT SIDE
OF PLAY SET
HOLES
FOR
CLATTER
BRIDGE
STEP 5: FRONT FRAME ASSEMBLY
1: PLACE THE 2 X 6 X 70" SANDBOX BOARD ON THE FRONT OF THE CORNER POSTS. THE OFFSET HOLES IN THE
SANDBOX BOARD SHOULD FACE UP.
2: USE 5/16 X 4-1/2" HEX BOLTS AND 5/16" WASHERS TO ATTACH THE TOP HOLES OF THE SANDBOX BOARD TO THE T-
NUTS INSTALLED ON THE CORNER POSTS. THE BOTTOM HOLES WILL BE USED LATER.
3: PLACE THE 2 X 6 X 70" FRONT FACE BOARD WITH NOTCHES ON THE FRONT OF THE CORNER POSTS. THE OFFSET
HOLES IN THE FRONT FACE BOARD SHOULD FACE UP.
4: USE 5/16 X 4-1/2" HEX BOLTS AND 5/16" WASHERS TO ATTACH THE TOP HOLES OF THE FRONT FACE BOARD TO THE
T-NUTS INSTALLED ON THE CORNER POSTS. THE BOTTOM HOLES WILL BE USED LATER.
5: PLACE THE 2 X 6 X 70" TOP PANEL BOARD ON THE FRONT OF THE CORNER POSTS. THE OFFSET HOLES IN THE TOP
PANEL BOARD SHOULD FACE UP.
6: USE 5/16 X 4-1/2" HEX BOLTS AND 5/16" WASHERS TO ATTACH THE TOP HOLES OF THE TOP PANEL BOARD TO THE T-
NUTS INSTALLED ON THE CORNER POSTS.
37