Instructions / Assembly

TEE NUT
4 X 4 X 108"
CORNER POST
NO TEE NUTS
IN THESE HOLES
(FOR ROPE LADDER
SUPPORT
NO TEE NUTS
IN THESE HOLES
(FOR SWING BEAM
SUPPORT
FRONT OF PLAY SET
STEP 1: ATTACHING THE T-NUTS TO THE CORNER POSTS
1: THIS STEP IS CRITICAL TO BUILDING THE PLAY SET PROPERLY. IF ANY MISTAKES ARE MADE HERE, YOU WILL NEED TO
DISASSEMBLE THEN REASSEMBLE TO MAKE YOUR CORRECTIONS. MAKE SURE HOLES ARE FREE OF ANY
OBSTRUCTIONS. USE A BOLT TO CLEAN OUT ANY DEBRIS.
2: LAY OUT EACH OF THE 4 X 4 X 108" CORNER POSTS IN THE AREA YOU INTEND ON BUILDING THE PLAYSET.
3: USE THE DIAGRAM BELOW TO CORRECTLY IDENTIFY AND ORIENT THE NECESSARY DIRECTION THE POSTS SHOULD
FACE.
4: USE A HAMMER TO SEAT THE T-NUTS AFTER INSERTING THEM INTO THE HOLES SHOWN IN THE DIAGRAM BELOW.
5: THE BARREL OF THE T-NUT SHOULD GO INTO THE HOLE FIRST. HAMMER THE T-NUT UNTIL IT IS FLUSH/ALMOST FLUSH
TO THE CORNER POSTS.
LEFT SIDE
OF PLAY
SET
32