Instructions / Assembly

1: ASSEMBLE THE RADICAL RIDE 5 TUBE SLIDE FOLLOWING THE DIRECTIONS THAT CAME
WITH THE SLIDE. WHEN YOU GET TO STEP 3 IN THE RADICAL RIDE 5 INSTRUCTIONS **STOP**
AND USE THIS STEP INSTEAD TO MOUNT THE ENTRY PLATE AND ENTRY ASSEMBLY TO THE
CLATTER BRIDGE TOWER.
2: ATTACH THE ENTRY PLATE AND ENTRY SECTIONS TOGETHER AT THE MIDDLE HOLE AS
SHOWN BELOW ON EACH SIDE. USE A 5/16" X 3/4" HEX BOLT, TWO 5/16" WASHERS AND A
LOCK NUT FOR THIS.
3: ALIGN THE TOP OF THE ENTRY PLATE WITH THE TOP OF THE 4 X 4 LAG POSTS INSTALLED
EARLIER.
4: ATTACH ENTRY PLATE TO THE LAG POSTS WITH 5/16" X 3-1/2" LAG SCREWS AND 5/16"
WASHERS AS SHOWN BELOW. DO NOT USE THE BOTTOM HOLE IN THE ENTRY PLATE. ONLY
USE THE TOP HOLES AND THE FOUR HOLES YOU DRILLED IN STEP 26.
YOU MAY HAVE NOTICED THAT BOLT HEADS OR NUTS ARE SANDWICHED BETWEEN THE
ENTRY PLATE AND THE LAG POSTS. THIS IS NORMAL.
5: FOLLOW THE REMAINING STEPS IN THE RADICAL RIDE 5 TUBE SLIDE
INSTRUCTIONS TO COMPLETE THE SLIDE ASSEMBLY.
STEP 27: ATTACHING RADICAL RIDE SLIDE
A
BOLT ENTRY PLATE TO ENTRY
SECTION ON BOTH SIDES WITH 5/16"
X 3/4" HEX BOLT, TWO 5/16"
WASHERS AND ONE 5/16" LOCK
WASHER.
ATTACH ENTRY PLATE TO LAG
POSTS WITH 5/16" X 3-1/2" LAG
SCREWS WITH 5/16" WASHERS IN
THESE HOLES ON BOTH SIDES. DO
NOT USE THE BOTTOM HOLE. ONLY
USE THE TOP HOLES AND THE FOUR
HOLES YOU DRILLED IN STEP 26.
ALIGN TOP OF
ENTRY PLATE
WITH TOP OF 4 X
4 LAG POST.
DO NOT USE THIS HOLE!
125