Instructions / Assembly

Lag Screw
OF SET
90"
Post
96"
Post
5/16" x 3-1/2"
96"
Post
Hex Bolt
5/16" x 4-1/2"
90"
Post
Panel
(OFFSET UP)
Supports
Deck
Supports
T-
NUT
2 x 4 x 19-3/8"
2 x 4 x 19-3/8"
Panel Supports
(OFFSET UP)
5/16"
Washer
FRONT
REAR OF SET
A
STEP 36: PANEL SUPPORTS
1: Hammer three 5/16" T-nuts into the holes on the inside of each of the 4 x 4 x 90" Corner Posts.
2: Place a 2 x 4 x 19-3/8" Panel Support (OFFSET UP) at the top, middle and lower positions on the outside of the
corner posts.
3: Fasten each Panel Support to the 90" Corner Posts with a 5/16" x 4-1/2" hex bolt and a 5/16" washers.
4: Make sure the main deck is level. Level the Deck Supports. Shim the 90" Corner Posts up or down until both
Deck Supports are level.
5: Go to the top Panel Support on the Front of the playset. Use a square to make sure it is square to the 96"
Corner Post. The end of the Panel Support must be flush to the inside of the 96" Corner Post. Now use a 5/16" x 3-
1/2" lag screw with 5/16" washer to fasten the Panel Support to the 96" Corner Post. Repeat this process for the
remaining two Panel Supports on the Front of the playset.
6: Repeat the process described in substep 5 to secure the Panel Supports on the Rear of the playset.
Panel Support
Hex Bolt
5/16" X 4-1/2"
Lag Screw
5/16" X 3-1/2"
2 x 4 x 19-3/8"
DETAIL A
5/16" Washer
(OFFSET UP)
5/16" T-nut
5/16" Washer
END MUST BE FLUSH
TO INSIDE FACE OF POST
77