Instructions / Assembly

2 x 4 x 12"

Bottom Panel

Board - LEFT

(OFFSET HOLES UP)

5/16" Washer

2 x 4 x 12"

Bottom Panel

Board - RIGHT

(OFFSET HOLES UP)

5/16" x 4-1/2"

Hex Bolt

5/16" Washer

FRONT

5/16" x 3-1/2"

Lag Screw

5/16" x 3-1/2"

Lag Screw

2 x 6 x 47-3/8"

Arched Side Top Board

1: Place one Arched Side Top Board on the rear of the set where shown. Attach the

Arched Side Top Board through the top holes with 5/16" x 4-1/2" hex bolts with washers.

Then attach the bottom holes with 5/16" x 3-1/2" lag screws with washers.

2: Place the 2 x 4 x 12" Bottom Panel Board - Left and 2 x 4 x 12" Bottom Panel Board -

Right on top of the 2 x 4 as shown below with offset holes up. Attach each Bottom

Panel Board with one 5/16" x 3-1/2" lag screw and one 5/16" washer.

STEP 21A: ARCHED TOP AND PANEL SUPPORT BOARDS