Instructions / Assembly

T-NUT
STEP 2: INSERTING T-NUTS INTO CORNER POSTS
1: Use a hammer to seat the t-nuts after inserting them into the holes shown in the diagram
below.
2: The barrel of the t-nut should go in the hole first. Hammer the t-nut until it is flush/almost flush
to the corner posts. No t-nuts will be installed in the Right or Left Corner Posts where shown
below.
(FRONT - LEFT)
CORNER POST #1
(REAR - RIGHT)
CORNER POST #3
(FRONT- RIGHT)
CORNER POST #4
(REAR - LEFT)
CORNER POST #2
NO T-NUT
IN THESE HOLES
NO T-NUT
IN THESE HOLES
38