Instructions / Assembly

REAR EDGE is inset about
4-1/2" from this board.
#14 X 1-1/4"
Pan Head Screws
** DO NOT PICK UP END OF SLIDE AFTER IT IS INSTALLED **
STEP 68: WAVE SLIDE
1: Place the Wave Slide centered in the opening at the front of the playset.
2: Place the rear edge of the slide about 4-1/2" in from the board on the front of the playset.
3: Fasten the slide to the deck using #14 X 1-1/4" pan head screws.
HINT: You may use a 1/8" drill bit to predrill holes through the dimples in the slide into the deck
board if you wish.
**ONCE THE SLIDE IS FASTENED DO NOT PICK THE SLIDE UP FROM THE END.**
110