Instructions / Assembly

STEP 57: ROOF STARTERS

1: Place the 1 x 5 x 52" (groove only) Roof Starter boards at the peak of the roof. Measure at

the bottom of the roof supports. In this case for example the measurement is 47-3/8". After

you install the Roof Starters the dimension at the top should be 47-3/8" also. (The dimension

between the Roof Supports for your set could vary from the 47-3/8" mentioned below.)

2: The Roof Starters should be placed as close together as possible near the peak without

the boards overlapping.

3: Fasten the Roof Starters to the Roof Supports with #8 x 1-1/2" wood screws.

Wood Screw

#8 x 1-1/2"

Roof Starter

1 x 5 x 52"

Boards should be placed

as close together as possible

without them overlapping.

DETAIL A

SCALE 1 : 14

1 x 5 x 52"

Roof Starter

" Overhang

(approximately)