Instructions / Assembly

STEP 16: LOWER LEVEL PANEL BOARDS
1: PLACE THE 2 X 4 X 35.5" TOP PANEL BOARD FLUSH TO THE CONNECTOR POST. ATTACH THE COUNTERSUNK
HOLE OF THE TOP PANEL BOARD TO THE T-NUT INSTALLED IN THE CONNECTOR POST USING ONE 5/16" X 4-1/2"
HEX BOLT AND ONE 5/16" WASHER. ATTACH THE OPPOSITE COUNTERSUNK HOLE OF THE TOP PANEL BOARD TO
THE T-NUT INSTALLED IN THE LOWER LEVEL CORNER POST USING ONE 5/16" X 4-1/2" HEX BOLT AND ONE 5/16"
WASHER.
2: PLACE A LEVEL ON TOP OF THE TOP PANEL BOARD TO ADJUST IT UP OR DOWN. VERIFY THAT THE CORNER
POST IS PARALLEL TO THE CONNECTOR POSTS BY PLACING A LEVEL AGAINST THE FRONT FACE OF THE CORNER
POST.
3: PLACE THE 2 X 6 X 39" BOTTOM PANEL BOARD (HOLES OFFSET UP) FLUSH TO THE LOWER LEVEL CORNER POST
AND THE FRONT CORNER POST (MAIN LEVEL). FASTEN THE TOP FRONT HOLE OF THE BOTTOM PANEL BOARD TO
THE T-NUTS INSTALLED IN THE LOWER LEVEL CORNER POST USING ONE 5/16" X 4-1/2" HEX BOLT AND ONE 5/16"
WASHER.
4: MAKE SURE THE BOTTOM PANEL BOARD IS LEVEL AND FLUSH TO THE FRONT CORNER POST (MAIN LEVEL) AND
ATTACH THE TOP HOLE TO THE FRONT CORNER POST (MAIN LEVEL) USING ONE 5/16" X 3-1/2" LAG SCREW AND
ONE 5/16" WASHER.
5: REPEAT SUB-STEPS 1 TO 4 FOR THE OTHER SIDE.
CORNER POST
LEVEL
(MAIN LEVEL)
CORNER POST
LOWER LEVEL
POST
CONNECTOR
HEX BOLT
5/16" WASHER
5/16" WASHER
5/16" X 4-1/2"
HEX BOLT
5/16" X 4-1/2"
LAG
5/16" X 3-1/2"
WASHER
5/16"
FRONT
(OFFSET UP)
2 X 4 X 35.5"
BOARD
PANEL
BOARD
TOP PANEL
(MAIN LEVEL)
CORNER POST
2 X 6 X 39"
BOTTOM
FRONT
CONNECTOR
POST
16
"
"
2
35
1
"
2
35
1
"
2
35
1
1
35 "
2
"
16
28
5
"
16
28
5
28
5
28
5
16
"
77