Instructions / Assembly

STEP 6: FRONT FRAME ASSEMBLY
1: PLACE THE 2 X 6 X 70" SANDBOX BOARD ON THE FRONT OF THE CORNER POSTS. THE HOLES IN THE SANDBOX
BOARD SHOULD BE OFFSET UP.
2: USE 5/16 X 4-1/2" HEX BOLTS AND 5/16" WASHERS TO ATTACH THE TOP HOLES OF THE SANDBOX BOARD TO THE
T-NUTS INSTALLED IN THE CORNER POSTS. THE BOTTOM HOLES WILL BE USED LATER.
3: MEASURE UP 29-5/8" FROM THE TOP OF THE FRONT DECK SUPPORT AND MAKE A MARK ON THE BACK OF EACH
FRONT CORNER POSTS.
4: PLACE THE 2 X 4 X 70" TOP PANEL BOARD ON THE MARKS. THE HOLES IN THE TOP PANEL BOARD SHOULD BE
OFFSET UP.
5: USE 5/16 X 3-1/2" LAG SCREWS AND 5/16" WASHERS TO ATTACH THE TOP PANEL BOARD TO THE BACK OF THE
FRONT CORNER POSTS. THE CENTER HOLE WILL BE USED LATER.
SUPPORT
F
R
O
N
T
O
F P
L
A
Y
S
E
T
R
E
A
R
O
F P
L
A
Y
SE
T
HEX BOLT
(HOLES OFFSET UP)
5/16" X 3-1/2" LAG SCREW
5/16" WASHER
EMPTY
TOP PANEL BOARD
5/16" WASHER
FRONT CORNER POST
2 x 4 x 70"
(HOLES OFFSET UP)
5/16" X 4-1/2"
SAND BOX BOARD
2 X 6 X 70"
FRONT DECK
FRONT CORNER POST
29
5
8
"
67