Instructions / Assembly

STEP 49: PANEL BOARD
1: USE A HAMMER TO SEAT THE T-NUTS AFTER INSERTING THEM INTO THE HOLES SHOWN IN THE
DIAGRAM BELOW.
2: CONNECT THE UPPER LEVEL CORNER POST AND THE LAG POST WITH ONE 2 X 4 X 30.625"
PANEL/DECK SUPPORT AT THE TOP OF THE POSTS AND FASTEN WITH 5/16" X 4-1/2" HEX BOLTS
AND 5/16" WASHERS.
3: FIND ANOTHER 2 X 4 X 30.625" PANEL/DECK SUPPORT AND ATTACH TO THE UPPER LEVEL
CORNER POST AND TO THE LAG POST USING ONE 5/16" X 4-1/2" HEX BOLT WITH ONE 5/16"
WASHER ON ONE END AND ONE 5/16" X 3-1/2" LAG SCREW WITH ONE 5/16" WASHER ON THE
OTHER END AS SHOWN BELOW.
HEX BOLT
T-NUT
5/16" X 4-1/2"
5/16" WASHER
SUPPORT
/DECKPANEL
2 X 4 X 30.625"
SUPPORT
5/16" WASHER
/DECK
LAG SCREW
5/16" X 3-1/2"
HEX BOLT
5/16" WASHER
5/16" WASHER
5/16" X 4-1/2"
HEX BOLT
LAG POST
5/16" X 4-1/2"
2 X 4 X 30.625"
PANEL
4 X 4 X 96"
UPPER LEVEL CORNER POST
87