Instructions / Assembly

SUPPORT

CORNER POST

TORQUE WASHER

4 X 4 X 96" UPPER LEVEL

CARRIAGE BOLT

3/8" WASHER

3/8" LOCK NUT

BOLT CAP

3/8" X 6-1/2"

CONNECTOR

3/8" WASHER

CONNECTOR

SUPPORT

3/8" X 5" LAG SCREW

STEP 46: UPPER LEVEL CORNER POST

1: FIND ONE 4 X 4 X 96" UPPER LEVEL CORNER POST AND FASTEN TO THE CONNECTOR

SUPPORTS USING 3/8" X 6-1/2" CARRIAGE BOLT AND TORQUE WASHER. PLACE THE CARRIAGE

BOLT INTO THE TORQUE WASHER, THEN INTO THE HOLE OF THE CORNER POST AND SET WITH A

HAMMER. USE 3/8" LOCK NUT AND 3/8" WASHER TO SECURE THE UPPER LEVEL CORNER POST

FROM THE OTHER SIDE. PLACE A BOLT CAP OVER THE EXPOSED THREADS AFTER SECURING.

2: MAKE SURE THE UPPER LEVEL CORNER POST IS PLUMB AND LEVEL IN ALL DIRECTIONS AND

SECURE USING A 3/8" X 5" LAG SCREW AND 3/8" WASHER AS SHOWN IN THE DIAGRAM BELOW.