Instructions / Assembly

BOLT CAP

3/8" X 6-1/2"

CARRIAGE BOLT

TORQUE WASHER

3/8" WASHER

HOLE WILL NOT BE

USED.

3/8" LOCK NUT

THIS HOLE IS TO BE

USED ONLY IF YOUR

YARD RUNS UP-HILL.

IF INSTALLING YOUR

PLAY SET ON

RELATIVELY LEVEL

GROUND THEN THIS

COUNTER-SUNK

HOLES FACE OUT

4 X 4 X 47-3/8"

SWING BEAM MOUNT

STEP 26: SWING BEAM MOUNT

1: THE 4 X 4 X 47-3/8" SWING BEAM MOUNT HAS COUNTER-SUNK HOLES IN THE CENTER AND ON

THE ENDS. INSTALL THE SWING BEAM SUPPORT SO THAT THE COUNTER-SUNK HOLES ON EACH

END OF THE BEAM FACE OUT, AND THE COUNTER-SUNK HOLES IN THE CENTER FACE DOWN.

2: FASTEN THE SWING BEAM MOUNT TO THE RIGHT CORNER POST USING 3/8" X 6-1/2" CARRIAGE

BOLTS AND TORQUE WASHERS. PLACE THE CARRIAGE BOLT INTO THE TORQUE WASHER, THEN

INTO THE HOLE OF THE CORNER POST AND SET WITH A HAMMER. USE 3/8" LOCK NUTS AND 3/8"

WASHERS TO SECURE THE SWING BEAM MOUNT FROM THE OUTSIDE. PLACE BOLT CAPS OVER

THE EXPOSED THREADS AFTER SECURING.

NOTE: THERE ARE TWO MOUNTING POSITIONS FOR THE SWING BEAM MOUNT. USE THE LOWER

HOLES IN THE RIGHT CORNER POSTS IF YOUR YARD IS RELATIVELY FLAT. IF YOUR YARD RUNS

UPHILL THEN YOU SHOULD USE THE UPPER HOLES IN THE RIGHT CORNER POSTS.