Instructions / Assembly

STEP 8: FORT SUPPORTS
1: PLACE A 5/16" T-NUT INTO THE HOLE IN THE FORT SUPPORTS AS SHOWN.
2: FROM THE INSIDE OF THE RIGHT PANEL BOARD LOOSELY ATTACH EACH FORT SUPPORT WITH
ONE 5/16" X 2-1/2" HEX BOLT AND ONE 5/16" WASHER.
3: MEASURE 2" AND 3-1/2" DOWN FROM THE TIP OF EACH FORT SUPPORT AND DRILL A 1/8"
HOLE THROUGH THE FORT SUPPORT ALONG THE CENTER. (SEE DETAIL A)
4: PLACE EACH FORT SUPPORT AGAINST THE CORNER POST. THE SIDE OF THE FORT SUPPORT
SHOULD BE FLUSH WITH THE RIGHT SIDE OF THE RIGHT CORNER POSTS.
5: ATTACH THE ANGLED END OF EACH FORT SUPPORT WITH ONE 2-1/2" WOOD SCREW AND
ONE 3" WOOD SCREW. TIGHTEN EACH 5/16" X 2-1/2" HEX BOLT.
HEX BOLT
FORT SUPPORT
5/16" X 2-1/2" HEX BOLT
5/16" WASHER
T-NUT
5/16" X 2-1/2"
2 X 4 X 48"
T-NUT
5/16"
WASHER
2 X 4 X 48"
FORT SUPPORT
A
3"
WOOD
SCREW
DETAIL A
SCALE 1 : 9
2-1/2"
WOOD
SCREW
2"
3
1
2
"
46