Instructions / Assembly

T-NUT

(OFFSET HOLES DOWN)

DECK SUPPORT

2 X 4 X 47-3/8"

(HOLES OFFSET DOWN)

DECK SUPPORT

FRONT ARCH BOARD

2 X 6 X 47-3/8"

HEX BOLT

5/16" WASHER

T-NUT

2 X 4 X 47-3/8"

5/16" X 4-1/2"

T-NUT

STEP 6: PANEL SUPPORTS AND DECK SUPPORTS

1: USE A HAMMER TO SEAT THE T-NUTS AFTER INSERTING THEM INTO THE HOLES SHOWN IN THE

DIAGRAM BELOW.

2: THE 2 X 6 X 47-3/8" FRONT ARCH BOARD ATTACHES TO THE FRONT OF THE LEFT AND RIGHT

CORNER POSTS WITH TWO 5/16" X 4-1/2" HEX BOLTS AND TWO 5/16" WASHERS.

3: ATTACH THE 2 X 4 X 47-3/8" DECK SUPPORTS (OFFSET HOLES DOWN) TO THE INSIDE OF THE

LEFT AND RIGHT CORNER POSTS WITH TWO 5/16" X 4-1/2" HEX BOLTS AND TWO 5/16" WASHERS.