Instructions / Assembly

STEP 54: SLIDE BLOCK

1: FIND THE 4 X 4 X 23.5" SLIDE BLOCK WITH TWO COUNTER SUNK HOLES AND TEMPORARILY

PLACE IT AGAINST THE DECK SUPPORT. USE THE COUNTER SUNK HOLES AS A DRILL TEMPLATE

AND DRILL TWO 3/8" HOLES INTO THE DECK SUPPORT.

2: REMOVE THE SLIDE BLOCK. USE A HAMMER TO SEAT THE T-NUT AFTER INSERTING IT INTO THE

DECK SUPPORT PRE-DRILLED HOLES FROM THE BACK.

3: MOUNT THE SLIDE BLOCK AGAINST THE DECK SUPPORT AND LINE UP THE COUNTER SUNK

HOLES WITH THE PRE-DRILLED HOLES AND FASTEN USING 5/16" X 4-1/2" HEX BOLTS AND 5/16"

WASHERS.

4 X 4 X 23.5" SLIDE BLOCK

5/16" X 4-1/2" HEX BOLT

DECK SUPPORT

T-NUT T-NUT

DRILL 3/8" HOLES HERE

5/16" WASHER