Instructions / Assembly

76-7/8" ROOF STARTER LENGTH

OVERHANG OVERHANG

DIM A

72.75" EXAMPLE DIMENSION

DIM B

END OF THE ROOF STARTER SHOULD BE PLACED FLUSH TO THE PEAK OF THE ROOF

SUPPORTS.

4.125" DIVIDED BY 2 EQUALS 2.063" OVERHANG

PEAK OF THE ROOF.

2: FASTEN THE ROOF STARTER REAR TO THE ROOF SUPPORTS WITH 1-1/2" WOOD SCREWS.

TOP OF ROOF

SUPPORT AT THE

ROOF STARTER

IN THE ROOF STARTER SHOULD BE CENTERED ON THE ROOF SUPPORTS, AND THE FLAT TOP

1: PLACE THE 1 X 4 X 76-7/8" ROOF STARTER BOARD AT THE PEAK OF THE ROOF. THE HOLES

EACH SIDE TO KEEP YOUR ROOF SUPPORTS PARALLEL.

NUMBER BY 2. THIS WILL GIVE YOU THE OVERHANG FOR EACH SIDE. USE THE OVERHANG NUMBER ON

THE INSIDE OF THE ROOF SUPPORTS SLIGHTLY. SUBTRACT DIM A FROM 76-7/8" AND THEN DIVIDE THIS

EXAMPLE: 76-7/8" MINUS 72.75" EQUALS 4.125".

THE ROOF STARTER WILL EITHER BE CENTERED ON THE ROOF SUPPORTS OR THEY WILL OFFSET TOWARDS

THE ROOF SUPPORTS PARALLEL TO EACH OTHER. DUE TO WOOD MILLING VARIATIONS YOUR HOLES IN

PER SIDE.

MEASURE DIM A ACROSS THE BOTTOM OF THE ROOF SUPPORTS NEAR THE CORNER POSTS. WHEN

ATTACHING THE ROOF STARTER DIM B AT THE ROOF PEAK SHOULD MATCH DIM A. THIS WILL MAKE

BOTTOM OF ROOF

SUPPORT ATTACHED

TO CORNER POST.

STEP 60: ROOF STARTER REAR

(3-1/4" WIDE)

1 X 4 X 76-7/8"

ROOF STARTER REAR

1-4-7688-RSR

1-1/2" WOOD SCREW

112