Instructions / Assembly

BETWEEN THESE THREE HOLES.

NOW GO BACK AND ADD

THE 2 X 6 FLOOR BOARDS.

2-1/2" SCREWS TO THE HOLES

2 X 4 X 95-1/2"

MIDDLE FLOOR BOARD

THREE RAMP SUPPORTS INTO

WOOD SCREW

2-1/2"

2 X 6 X 95-1/2"

FLOOR BOARD

PLACE ONE 2-1/2" WOOD

SCREW ABOVE EACH OF THE

FLUSH

NOTE SCREW HOLES SHOULD BE

APPROXIMATELY CENTERED OVER THE

RAMP SUPPORTS

STEP 17: CLIMBING RAMP

1: PLACE ONE 2 X 6 X 95-1/2" FLOOR BOARD AGAINST EACH OF THE RAMP SIDE BOARDS. FASTEN THE FLOOR

BOARDS TO THE RAMP SUPPORT BOARDS WITH TWO 2-1/2" WOOD SCREWS PER SUPPORT. THE BOARDS SHOULD BE

FLUSH AT THE SQUARE END OF THE RAMP SIDES.

2: PLACE THE 2 X 4 X 95-1/2" MIDDLE FLOOR BOARD ON THE CENTER OF THE RAMP. FASTEN THE FLOOR BOARD TO

THE RAMP SUPPORT BOARDS WITH TWO 2-1/2" WOOD SCREWS PER RAMP SUPPORT.

3: ABOVE EACH OF THE RAMP SUPPORTS PLACE ONE 2-1/2" WOOD SCREW THROUGH THE RAMP SIDE BOARDS

INTO THE 2 X 6 FLOOR BOARDS. BETWEEN EACH RAMP SUPPORT, INSTALL TWO MORE 2-1/2" WOOD SCREWS

THROUGH THE RAMP SIDE INTO THE FLOOR BOARD.