Instructions / Assembly

POSTS
CORNER
FRONT OF FORT
NOT HAVE.
POSTS DO
THE FRONT
HERE THAT
EXTRA HOLE
HOLES AT THE TOP OF THE CORNER
POSTS SHOULD BE FACING THIS DIRECTION.
HAVE AN
LEFT SIDE OF FORT
BEAM MOUNT USING
CARRIAGE BOLTS.)
NO T-NUT IN THESE
HOLES (FOR SWING
CORNER
POST
CORNER
POST
4 X 4 X 120"
MIDDLE
MIDDLE
NOT HAVE.
POSTS DO
THE FRONT
4 X 4 X 108"
FRONT
4 X 4 X 120"
MIDDLE
CORNER
POST
MIDDLE
CORNER
POSTS
HAVE AN
EXTRA HOLE
HERE THAT
RIGHT
SIDE OF
FORT
STEP 1: ATTACHING T-NUTS TO THE CORNER POSTS
1: THIS STEP IS CRITICAL TO BUILDING THE FORT PROPERLY. IF ANY MISTAKES ARE MADE HERE, YOU WILL NEED TO
DIS-ASSEMBLE AND THEN RE-ASSEMBLE TO MAKE YOUR CORRECTIONS.
2: MAKE SURE HOLES ARE FREE OF ANY OBSTRUCTIONS. USE A BOLT TO CLEAN OUT ANY DEBRIS.
3: LAY OUT EACH OF THE 4 X 4 X 108" CORNER POSTS AND 4 X 4 X 120" MIDDLE CORNER POST IN THE AREA YOU
INTEND ON BUILDING THE FORT SIDE OF THE PLAYSET.
4: USE THE DIAGRAM BELOW TO CORRECTLY IDENTIFY AND ORIENT THE NECESSARY DIRECTION THE POSTS
SHOULD FACE.
5: USE A HAMMER TO SEAT THE T-NUTS AFTER INSERTING THEM INTO THE HOLES SHOWN IN THE DIAGRAM BELOW.
6: THE BARREL OF THE T-NUT SHOULD GO IN THE HOLE FIRST. HAMMER THE T-NUT UNTIL IT IS FLUSH/ALMOST FLUSH
TO THE CORNER POSTS.
47