Instructions / Assembly

(TEST FIT ONLY)

EMPTY

OVERHANG

ROOF

TOP PANEL BOARD

(TEST FIT ONLY)

GABLE ASSEMBLY

FINISHER RIGHT

1 X 4 X 29.29" ROOF

ROOF

OVERHANG

1 X 4 X 29.29" ROOF

FINISHER LEFT

EMPTY

EQUAL

NOTE:

CORNER POST

REMOVED

FOR CLARITY

1-1/2"

WOOD SCREW

PULL TOWARDS YOU

-7

STEP 35: ATTACHING THE FRONT GABLE

1: MOUNT THE GABLE ASSEMBLY RESTING ABOVE THE TOP PANEL BOARD, MAKE SURE THE GABLE ASSEMBLY IS

FLUSH AGAINST THE FRONT CORNER POSTS. THE GABLE ROOF PEAK SHOULD BE RESTING ON TOP OF THE ROOF

FRONT SECTION.

TIP: MAKE SURE THE DISTANCE BETWEEN THE GABLE ASSEMBLY AND THE ROOF OVERHANG IS EQUAL ON BOTH

SIDES. IT IS RECOMMENDED TO TEST FIT THE 1 X 4 X 29.29" ROOF FINISHERS FRONT LEFT AND RIGHT TO ASSURE THIS

EQUAL DISTANCE (DO NOT FASTEN). IF NECESSARY SLIDE THE GABLE ASSEMBLY LEFT OR RIGHT UNTIL FINAL

POSITION IS ACCOMPLISHED.

2: THE GABLE ASSEMBLY BOTTOM COUNTERSUNK HOLES WILL REMAIN EMPTY FOR NOW.

3: AFTER THE GABLE ASSEMBLY IS IN ITS FINAL

POSITION. GO INSIDE ON TOP OF THE DECK

AND PULL THE GABLE ASSEMBLY TOWARDS

YOU MAKING SURE IT IS FLUSH TO THE

OUTSIDE OF THE ROOF AND INSERT TWO 1-

1/2" WOOD SCREWFROM UNDERNEATH THE

ROOF INTO THE GABLE ASSEMBLY ROOF

PEAK. USE THE DIMENSIONS SHOWN IN THE

DIAGRAM TO THE LEFT TO INSERT THE WOOD

SCREWS IN THE CORRECT LOCATION.

REMOVE THE ROOF FINISHERS, THESE WILL BE

USED IN A LATER STEP.