Installation Guide

T-NUT
HEX BOLT
ROOF SUPPORT ASSEMBLY
5/16" WASHER
#8 X 2-1/2" WOOD
SCREW
5/16" X 4-1/2"
CENTER POST
5/16" WASHER
T-NUT
5/16" X 4-1/2" HEX BOLT
STEP 25: ROOF SUPPORTS
1: INSERT T-NUTS INTO THE UPPER HOLES OF THE CORNER POSTS FROM THE INSIDE OF THE FORT
AND SET WITH A HAMMER.
2: PLACE THE ROOF SUPPORT ASSEMBLY OUTSIDE THE FORT AGAINST THE CORNER POSTS.
ATTACH USING 5/16" X 4-1/2" HEX BOLT AND 5/16" WASHERS INTO THE COUNTERSUNK HOLES
OF THE ROOF SUPPORTS INTO THE T-NUTS INSTALLED IN THE CORNER POSTS.
3: INSERT TWO #8 X 2-1/2" WOODSCREWS THROUGH THE CENTER POST INTO THE ROOF
SUPPORT ASSEMBLY AS SHOWN BELOW.
4: REPEAT SUB STEPS 2 & 3 FOR THE OTHER SIDE.
123