Instructions / Assembly

STEP 55: STEERING WHEEL

1: PLACE THE STEERING WHEEL INSERT INSIDE THE STEERING WHEEL. PLACE THE STEERING

WHEEL AGAINST THE END OF THE SWING BEAM.

2: MARK THROUGH THE HOLE IN THE STEERING WHEEL INSERT ONTO THE END OF THE

SWING BEAM. DRILL A 3/16" PILOT HOLE 2" DEEP INTO THE SWING BEAM.

3: USE THE 2-1/2" LAG SCREW AND WASHER TO FASTEN THE STEERING WHEEL TO THE

SWING BEAM. DO NOT OVER-TIGHTEN THE LAG SCREW OR THE STEERING WHEEL WILL

NOT TURN.

4: PLACE THE STEERING WHEEL CAP OVER THE CENTER OF THE STEERING WHEEL AND

SNAP IT INTO THE STEERING WHEEL INSERT.

WASHER

2-1/2" LAG SCREW

STEERING WHEEL CAP

INSERT

STEERING WHEEL

SWING BEAM